Dinan Carbon Fiber Intake for BMW | E9X 325is | N54 (NLA)
Dinan's Cold Air Intake system for the E92 335is adds an additional intake snorkel to complement the factory intake duct. The Dinan intake adds a new airbox cover and a carbon fiber intake snorkel that draws cooler air from a low pressure zone behind the front bumper. This location is a full 40 degrees cooler than the factory air inlet. A K&N panel filter replaces the stock filter in the stock airbox and a second K&N cone filter is located on the new snorkel. Professional installation is recommended but detailed instructions are included. Dinan has shown peak gains of 5hp and 6ft-lbs of torque from the intake alone but greater gains come at higher RPM where more airflow is required. Performance software is recommended. Beautiful and high quality carbon fiber dresses up the engine bay while also taking advantage of composite's superior thermal resistance.
Note: This kit requires the deletion of the auxiliary radiator in the front left of the car. A Dinan High Capacity Oil Cooler is required to maintain adequate engine cooling and warranty coverage. Dinan Performance Software is highly recommended.
Installation Instructions: Dinan E9X 325is Carbon Intake D760-0031 Installation
Features:
- +14 HP 6000 RPM / +16 lb/ft @ 3400 RPM
- Improved Throttle Response
- Inlet air temps reduced by nearly 40 degrees
- Aircraft quality carbon fiber airbox and tube captures cool air from the lower grille and increases air volume
2010-2013 E92 BMW 335is - Coupe 2010-2013 E93 BMW 335is - Convertible
.
Share:
)
