Home > Air Ride > Camber Kits >

034Motorsport Density Line Adjustable Upper Control Arm Kit | B8 Audi A4 | S4 & A5 | S5


034-401-1009 034Motorsport Density Line Adjustable Upper Control Arm Kit | B8 Audi A4 | S4 & A5 | S5



 
034-22906

Price:
$435.00



Camber Adj Needed

  

Qty:  
Product Info
 

Fully adjustable upper control arms for the B8 Audi A4/S4 are available in both Camber Correcting and Track Spec varieties.

Camber Correcting: Perfect for those who have lowered their car from OEM ride height and are looking to correct camber to factory specs and reduce excessive inside tire wear to add POSITIVE Camber. Part # 034-401-1008

Track Spec: Perfect for those who have lowered their car from OEM ride height and are looking to have even more NEGATIVE camber for better track performance or that perfect Stance look. Part # 034-401-1009

Features:

  • CNC Machined Billet 6061 Construction, Black Anodized Finish
  • 034Motorsport Density Inner Bushings
  • Aurora Spherical Bearings Featuring Teflon Race Lining
  • Built in Safety Washer to eliminate any chance of the spherical ever separating
  • Arm sets ship set to factory OEM length
  • Camber Correcting: These offer over 5/8" of outward adjustability from stock length, adjustable in 1/36" increments, each 1/36 adjustment is approximately .1 degrees for highly accurate adjustments.
  • Track Spec: Already 1/8" shorter than stock, these offer an additional 5/8" of inward adjustability from stock length, adjustable in 1/36" increments, each 1/36 adjustment is approximately .1 degrees for highly accurate adjustments.
  • No tightening creep like you get with a turn buckle.
  • Adjustments can be easily made by threading out an M6 head allen bolt, the pinch pin stays installed in the upright. A jam nut keeps everything tight once adjusted.
  • Dust boots are now included with all adjustable upper control arms. We ship the boots uninstalled; once you have the alignment set, install the dust boots before final installation.

Arms ship with everything pictured and assembled, price for one kit for one front suspension.

Note - Do not run the heims with less than 8 threads in the control arm itself, less threads can cause failure of the part and 034Motorsport will not be responsible for installation errors. If your alignment requires that you must have less than 8 threads engaged then contact us, but do not run the car with less than 8 threads engaged! Tighten M10 pan head allen bolt to 45 ft/lbs with blue loctite.

Control arms do not have to be removed to adjust camber. Please see the video below highlighting the ease of adjustment.