Water / Methanol injection solution for your VW / Audi 2.0T FSi/TSi
This kit features an optimized hardware package specifically for VW and Audi 2.0T TSI/FSI vehicles. The system utilizes a special controller that is designed to read the unique digital MAF sensor output signal. Utilizing your factory washer reservoir to hold the fluid for the system saves room and maximizes fluid capacity without giving up your windshield washer function.
• Digital MAF referenced controller
• 150+ psi pump for the most in pressure and volume
• Bulkhead fitting required to tap into factory washer reservoir
• 8 feet of tubing
• 2 nozzles to cover a wide range of horsepower
• All required hardware needed for installation
• 2.0T specific instructions for ease of installation
Use the drop-down menu above
Low Level Indicator
The indicator switch upgrade includes an LED and an EZ installation grommet for use with any Boost Cooler® reservoir or can be added to any plastic reservoir including factory windshield washer fluid tanks.
Shut off solenoid is used when mounting the injection nozzle lower than the reservoir or the reservoir is rear-mounted to prevent gravity flowing. It is also used to prevent siphoning when the injection nozzle is mounted after the throttle body or carburetor and is exposed to vacuum.
Boost Juice™ is Snow Performance’s proprietary mix of 49% methanol and 51% water. It is made in a controlled environment with special care to make sure the ratios are accurate to result in a high performance water-methanol fluid formulated for use in the Boost Cooler™ injection system. Boost Juice is required as the exclusive fluid for lifetime warranty.
*NOTE* Boost Juice CAN NOT be shipped outside of the United States. Boost Juice CAN ONLY be shipped using Ground service.