The Snow Performance MPG-MAX VW TDi water/methonalanol injection system provides more power, and excellent fuel economy increases. The The MPG-MAX system uses a new injection management controller that allows for a small spray of water/methonalanol to be injected across the power band. This provides an increase in combustion efficiency which provides more power without injecting more diesel fuel. This increase in efficiency translates into an increase in fuel economy. Independent testing by Diesel World Magazine showed fuel economy increases of 5%-15% (4 MPG on the TDi)and Power increases of 35 hp/ 40 lb. ft. in a 2010 Jetta TDi - see March 2010 Diesel World Magazine for results and data.
The MPG-MAX system has a secondary output that is used to activate a Power Mode. This introduces a second phase of injection. A larger nozzle is used to inject more fluid to make more power. The Power Mode activation point is adjustable for best performance. This allows for more injection when more power is needed. The MPG-MAX system has been coupled with the Snow Performance 2.5 Gallon trunk mount reservoir to provide a large fluid tank. This will provide long range and includes the necessary installation hardware.
Also, the system has an LCD screen that displays boost, exhaust gas temps and injection pump output. This means a savings of $200-300 in gauges you dont have to buy.
1. Will not adversely effect PM filter (particulate matter filter) like most other power adders.
2. Adds 40hp safely.
3. Doesnt leave a signature on vehicles computer so warranty isnt jeopardized.
4. Comes complete with large 2.5 gal. reservoir and all parts for VW for a truly complete system.
5. The most advanced system on the market true 2D mapping/ 2- nozzles controlled independently for smooth power always.
6. The only system proven (and designed specifically) to improve fuel economy.
7. Dash mounted module displays real time no need for gauges.
Use the drop-down menu above
Low Level Indicator
The indicator switch upgrade includes an LED and an EZ installation grommet for use with any Boost Cooler reservoir or can be added to any plastic reservoir including factory windshield washer fluid tanks.
Shut off solenoid is used when mounting the injection nozzle lower than the reservoir or the reservoir is rear-mounted to prevent gravity flowing. It is also used to prevent siphoning when the injection nozzle is mounted after the throttle body or carburetor and is exposed to vacuum.
Boost Juice is Snow Performances proprietary mix of 49% methonalanol and 51% water. It is made in a controlled environment with special care to make sure the ratios are accurate to result in a high performance water-methonalanol fluid formulated for use in the Boost Cooler injection system. Boost Juice is required as the exclusive fluid for lifetime warranty.
*NOTE* Boost Juice CAN NOT be shipped outside of the United States. Boost Juice CAN ONLY be shipped using Ground service.