DinanTronics Stage 4 Tuner for BMW | F30 | 328i | N20 (MWG) (NLA)

Stage 4 (DINANTRONICS Performance Tuner, Exhaust, Intercooler, & Big Turbo) Maximum Power: 345 HP, 336 lb-ft of torque.

In addition to increasing boost and optimizing the fuel and ignition data, the DinanTronics Power Module is tuned for the Dinan supporting modification, specifically the upgraded intercooler and big turbo kit on the N20. The Dinan tuner box plugs into the existing sockets on your engine computers The original wiring harness plugs into the Dinan tuner box. There is no cutting or splicing into wires and the whole harness is completely reversible at any time.

Because the DinanTronics module plugs directly into the engine computer, it can control the data from every sensor on the engine - not just the two or three that other piggyback-style modules use. Instead of only modifying a boost and RPM sensor, the Dinan power module sends a modified signal for fuel and ignition tables, target Lambda (AFR), exhaust temperature, knock sensors, and more. It has the ability to correct short term fuel trim and ignition timing errors so even as the boost increases through the whole RPM range the engine mapping remains where it should. Not only does it make a lot of peak power, but it's also a smooth and consistent power gain over the entire RPM band. The Dinan tuner module is the most sophisticated on the market and is the only one that is 50-state legal.

This kit fits cars with a mechanical wastegate, which was replaced with an electronic one around production date 6/2013. If your car was produced in June 2013 you should check which one your car has prior to ordering. Installation is plug and play but requires access to the entire engine compartment. The engine computer(s) is part of the intake manifold so access is tight. The Dinan module is installed under the radiator support and the harness has to be run to each computer. Detailed instructions are included but professional installation is strongly advised if you're not used to working around your engine.

Note: Dinan Intercooler and Big Turbo Upgrade is highly recommended to run this stage of software and retain warranty coverage. This version of the DINANTRONICS Performance Tuner is only compatible with vehicles equipped with the N20 engine. This version of the DINANTRONICS Performance Tuner is ONLY compatible with vehicles equipped with a mechanical wastegate. Vehicles with a manufacture date prior to 07/2013 should utilize a mechanical wastegate. Vehicles with a production date after 06/2013 should utilize an electronic wastegate. Only a visual identification is 100% accurate however. Please consult the wastegate identification guide HERE to accurately identify what is on the vehicle.

Benefits of the DINANTRONICS Stage 4 Performance Tuner for BMW N20 Engines:

• +84 HP @ 5500 RPM, +77 lb/ft @ 5500 RPM
• Won't void or negate your warranty
• Emissions legal in all 50 states
• Plug & play installation in two hours or less
• Quick, easy, and discrete installation

• Dinan Heat Exchanger/Intercooler
• Dinan Big Turbo Upgrade

VEHICLE FITMENT

• F30 BMW 328i / xDrive - N20 2.0L