IMPROVED - Torque wrench compatible! This double ended socket is just the ticket for MK-IV chassis Golf®/Jetta®/New Beetles® because the front struts have BOTH sizes to remove. Some earlier models (A3 chassis) that have VR6®-type strut bushings also require both sizes. The 8.5" long heat treated box wrench holds the socket using snap rings. Interior has a thru bore that allows you to reach inside and hold the strut shaft with a standard 6 or 7 mm hex bit (3/8" drive). The square hole in the handle permits the use of a torque wrench to set the nut torque to factory specs.
Heat treated alloy steel, Metalnerd® Brand USA.
Not for impact tool usage.