Integrated Engineering PCV Solution for 2.0T FSI Engines | IEBAVC17


Free Shipping
Integrated Engineering

Part# IEBAVC17

In Stock In Stock
Item is IN STOCK, order now and will ship out within 1 business day!
Dropship Direct Ship
This product will ship direct from our supplier. Availability is subject to suppliers stock.

Earn Rewards! +514 Points

One of the most common failures on the 2.0T FSI engine is the factory pressure-relief valve. These valves are in place to recirculate crankcase gases into the intake manifold once they open. Although this works fine for a few thousand miles, they begin to leak over time and cause boost to go past the valve into the valve cover. This not only causes an oily mess in the engine bay from crankcase pressure, but a rough idle, fuel economy decline and boost loss. With boost pressure far below where it should be, it is common to notice significant power losses and poor drivability.

easy install

Using our kit, you are able to completely remove the pressure-relief valve and replace it with a billet aluminum plate. This allows the factory breather system to function properly, while eliminating the failure-prone relief valve. With the hose between the valve cover and intake manifold completely eliminated, the included boost cap is used to block off the hose connection on the end of the intake manifold. Our billet cap features a tapped hole that can be plugged or used to plumb a boost gauge, compared to competitors products that do not offer a provision for plumbing a boost gauge.

billet aluminum

Installation of this kit is very straightforward and takes less than 20 minutes. You will immediately notice a drastic improvement in drivability and power if your valve was leaking previously.

Direct replacement for factory pressure-relief valve
Quick and simple installation
IE boost cap offers provision for plumbing boost gauge
Bright black anodized finish

Fits all timing belt-driven 2.0T FSI engines including:

2006-2008 MKV GTI/GLI
2012-2013 Golf R
2006-2008 1F7 Eos
2006-2008 B6 Passat
2006-2008 8P A3
2005-2008 B7 A4
2006-2008 MKII TT

About Integrated Engineering: Merging decades of experience with hundreds of hours of prototyping, engineering, dyno testing and daily usage evaluation has output exhaust systems that are the ultimate compliment to your performance car. IE products are proudly engineered, designed, and manufactured in-house, in Salt Lake City USA.

⚠️CALIFORNIA WARNING: Cancer and Reproductive Harm -

Can't find what you're looking for?
Odds are we can get it! Click Here Now