Eurodyne A4 2.0T CAEB Performance Software All Stages
- Share:
![email]()
![Facebook]()
![Twitter]()
![Pinterest]()
Select Your Car to Verify Fitment
Stage 1 - 267 HP / 330 LB-TQ ( +50 HP / +66 LB-TQ )
- Performance Software Precisely Engineered to Run on a Completely Stock Car.
- For at least 91 octane
Stage 2 - 280 HP / 355 LB-TQ ( +63 HP / +91 LB-TQ )
-
Required Hardware
- Upgraded Downpipe
-
Recommended Hardware
- Cold Air Intake or Short Ram
- Cat Back Exhaust System
- Ignition Timing Precisely Calibrated for 93 Octane Fuel
- Precisely Calibrated for an Upgraded Exhaust System
- Optimized for a High Flow Catalytic Converter
Installation
Flashed directly through the (OBDII) Diagnostic port of your vehicle (~30 minutes).
Powertap Flash Air Tool
The Powertap Air Flash Tool allows you to program your own vehicle right in your own garage either plugging in using your computer or wirelessly using your IOS Phone (Currently does not support Android)
Features for all Stages
- Engineered with Strict Industry Standards
- Extensively Tested Under Various Driving Conditions
- Factory Safety Limiters Retained
- Greatest Power and Torque Gains in the Industry, Guaranteed!
- Optimized Responsiveness and Drivability
- Optimized Smoothness and Driving Comfort
- Power Delivery Perfectly Optimized Throughout the Power Band
- Improved Fuel Efficiency
- Speed Governor Removed
- Lower End Hesitation (Lag) Removed
Stage 1 Graph
Stage 2 Graph
**LOCAL CUSTOMERS contact us for details on having your car tuned at our store. Call or Text 813-444-7021
NOTE: This software is also available to be installed locally at the UroTuning facility in Tampa Florida . Call us to setup an appointment at 813-444-7021
Powertap Air Flash Cable
This package will allow anyone with a Windows PC or tablet with USB port, and an internet connection to flash their ecu with our stage 1 or stage 2 software.
With the included Powertap interface and Eurodyne flash software you can switch between available stages and even flash the ecu back to stock if necessary.
Also included is diagnostic software that will allow you to check and clear fault codes, and datalog engine parameters.
Certain models support recoding of some modules as well. See the applicable stage 1 and stage 2 software product pages for details on power increases for your model.
We support port flashing for all models now, no ecu removal is required.
Screenshots for datalogging vary depending on the model. Due to the large number of different ecu codes, there may be a delay in adding support for new or rare software versions.
⚠️CALIFORNIA WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
